Rule 2

Rules for Electric Meter and Service Installations (REMSI)

07/09/2015 

  1. Standard Service Voltages
  2. Non-Standard Service Voltages
  3. Residential Service
  4. Combine Three Phase and Single Phase Loads
  5. Metering Equipment Not Used as Junction Box and/or Pull Box
  6. Service Termination Compartments Not Used as Pull Box or to Connect Customer Equipment
NOTES:
  1. 2 Wire Service Limited
  2. Residential Service at 120/208 Volts
  3. Single Phase, 3 Wire Service
  4. Three Phase, 4 Wire, 240 Volt, Delta Service
  5. Three Phase, 3 Wire, 480 Volt, Delta Service
  6. Three Phase, 4 Wire, 480Y Volt Service
  7. Single Phase, 3 Wire, 240/480 Volt Service

RULE 2 - Service Available At Secondary Voltage

  1. Standard Service Voltages:

    Secondary service is provided from the nearest suitable distribution line and, where required, PPL EU installs, owns and maintains one transformation from line voltage to one of the following standard secondary service voltages:

    Phase

    Wires

    Nominal Voltage

    Reference
    1 2 120 Note 1
    1 3 120/208 Note 2
    1 3 120/240 Note 3
    3 4 208Y Note 2
    3 4 480Y Note 6

  2. Non-Standard Service Voltages:

    Phase

    Wires

    Nominal Voltage

    Reference
    1 3 240/480 - single phase Note 7 (C)
    1 3 277/480* Note 6
    3 4 240 - Single Phase 120/240 ** Note 4
    3 3 480 ** Note 5

    * Available at customers expense - two additional transformers may be required.

    ** Special Permission Only.

  3. Residential Service:

    Standard service for residences is 3 wire, 120/208 or 120/240 Volt service with self-contained metering. Requests for higher voltages shall require the use of instrument transformers and the approval of PPL EU Metering Support.

  4. Combined Three Phase and Single Phase Loads:

    PPL EU has different ways of providing combined three phase power and single phase lighting loads for service to Industrial and Commercial services.

    For this reason each proposed new or additional load of this type shall be referred to PPL EU for full information on the kind of service to be provided.

  5. Metering Equipment Not Used as Junction Box and/or Pull Box:

    See Rule 12 for detailed information on Junction Box and/or Pull Box.

  6. Service Termination Compartments Not Used as Pull Box or to Connect Customer Equipment

    Service termination compartments shall not be used as pull boxes or to connect customer equipment. Taps and bugs are not permitted.

    Customer equipment shall not be installed or connected in service termination compartments. Only service entrance conductors can be connected in service termination compartments.

    Foreign energy sources shall not be connected in the service termination compartment. (See Definitions Page for more information on what PPL EU defines as Foreign Energy Source and Service Termination Compartment.)

NOTES:

  1. 2 Wire Service Limited:

    Single phase, 2 wire, 120 Volt service is available only for limited loads of approximately 3000 Watts or less which are served through a single 30 Ampere branch circuit, such as traffic signals, small signs, and cable television amplifier installations.

  2. Residential Service at 120/208 Volts:

    In areas where the secondary distribution system is 208Y Volts, three phase, 4 wire (grounded neutral), residential buildings with one or two dwelling units are served through a single phase, 3 wire, 120/208 Volt common service.

    Residential buildings with three or more dwelling units are served through a three phase, 4 wire, common service and the individual single phase, 3 wire, 120/208 Volt sub-services to the individual dwelling units shall be balanced as nearly as possible on the three phases.

    All services, other than residential, are served through three phase, 4 wire services except small establishments with limited loads requiring a service of 100 Ampere or less capacity. They may be served through a single phase, 3 wire service.

  3. Single Phase, 3 Wire Service:

    Single phase, 3 wire (grounded neutral) service is generally available for residential and general light and power service.

  4. Three Phase, 4 Wire, 240 Volt, Delta Service:

    Three phase, 4 wire (grounded neutral), 240 Volt delta connected service is only allowed by special permission where two phase distribution is available. If three phase distribution is available, wye connected service must be taken.

  5. Three Phase, 3 Wire, 480 Volt, Delta Service:

    Three phase, 3 wire, 480 Volt delta connected service is only allowed by special permission where two phase distribution is available. If three phase distribution is available, wye connected service must be taken.

  6. Three Phase, 4 Wire, 480Y Volt Service:

    Three phase, 4 wire, 480Y Volt service is provided for commercial and industrial services when 12 KV service is available.

    The maximum transformer bank on a single pole cluster mounted overhead installation is limited to a capacity of 500 KVA.

    See Rule 9 for details and specifications for installation of distribution type transformers in a vault or a pad mount three phase transformer.

    PPL EU can provide single phase, 3 wire service at 277/480 Volt for special applications, such as street lighting, highway lighting and special electric heating equipment.

  7. Single Phase, 3 Wire, 240/480 Volt Service:

    PPL EU can provide single phase, 3 wire service at 240/480 Volts for special applications, such as street lighting, highway lighting and special electric heating equipment at the customer's expense. (C)

(C) Indicates Change